![]() ![]() I'm unhappy about tackling the job because the wire is very thin.Īny thoughts or pointers would be much appreciated.ĭennis and all. I was thinking of making a simple winding machine then unwinding the outer layer onto another bobbin whilst counting the turns that come off. What is the thickness of the wire, please (SWG or AWG) ? What is the resistance supposed to be (red-blue terminals) ? Has anyone managed to successfully rewind one of these coils by hand, please? The wire seems very fine. I have checked to see if the break was (hopefully) where the red wire connects to the copper winding, but this was not the case. The red wire is connected to the most easily accessible point i.e. I've removed the outer layers of insulating tape and the dreaded green gunge syndrome is present on the outer layer of the winding. The other winding (red-blue terminals) is open circuit. I have measured 2400 Ohms across one winding (blue-green terminals). I disconnected the coil (red, blue, green terminals) in order to check the windings. Further to my previous post, I have performed some fault finding on this clock. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |